las hebras del dna y sus interacciones la importancia de las interacciones débiles jorge arévalo

LAS HEBRAS DEL DNA Y SUS INTERACCIONES

La importancia de las interacciones débiles

Jorge Arévalo

• Fuerzas que participan en las interacciones del Duplex DNA

• DNA – Proteína

• La tecnología de la hibridación

Fuerzas que participan en las interacciones del Duplex DNA

HERENCIA o el Flujo de Información vertical

1 nm

10 nm

100 nm

1

DNA

Virus

Bacteria

Proteins

0.1 nm

Nanotube

Nanowire

Next Generation CMOS

Current CMOS Technology

evo

luti

on

ary

te

chn

olo

gy

rev

olu

tio

na

ry t

ech

no

log

y

Nano-bio interface

Nanofiber

10.2 Most bacterial repressors are dimers containing helices that insert into adjacent

major grooves of operator DNA

Figure 10-13

10.2 Ligand-induced conformational changes alter affinity of many repressors

for DNA

Figure 10-14

Tryptophan binding induces a conformational change in the trp aporepressor

The backbone of the DNA strand consists of alternating sugar and phosphate groups

¿ Qué mantiene unidas a las hebras del DNA?

Una re-visita con mayor detalle

Chemical bonds are the basis of both form and function

• Covalent bonds are the strongest

• But non-covalent interactions have dramatic influence on biochemical reactions

– Electrostatic interactions

– Hydrogen bonding

– van der Waals interactions

Covalent Bonds

• Covalent bonds are the strongest and are formed when electrons are shared between two adjacent atoms.

• C-C bonds are about 1.54 Angstroms and have a bond energy of 85 kcal/mol while C-O double bonds have an energy of 175 kcal/mol.

Electrostatic interactions

E=kq1q2/Dr

Monovalent ions in solution produce electrostatic bonds of about 1.4 kcal/mole

The base pairs are stacked on top of each other along the length of the DNA double helix

Specific base pairing (hydrogen bonding) between the bases of the two strands stabilizes the double helix

Water

• Non-covalent bonds are altered by the medium in which atoms are surrounded. For most biochemical reactions, the medium is water.

• Water is a asymmetric molecule.

• Due to it’s particular asymmetry, water is highly cohesive molecule and forms extensive hydrogen bonding networks with itself.

Water significantly weakens electrostatic and hydrogen bonds in molecules

Hydrogen bonds are dependent on geometry

Hydrogen bonds

Hydrogen bonds are formed between hydrogen donors (that have hydrogen) and

hydrogen acceptors (that lack hydrogen) and are essential partial electrostatic interactions.

Typical hydrogen bonds have

energies of 1-3 kcal/mole

Physical and chemical properties of DNA

• H bonding contributes little to the overall stability of ds DNA

• Stacking interactions result from hydrophobic forces– Van der Waals– dipole interactions

• Stability is sequence specific!

Stacked Stacking energy dimer kJmol-1

CG -61GCAT -16 TA

Fig. 23-.20

- stacking : aromatic moieties possess electronic quadrupole moments, with - delocalized -electron cloud and + for atoms outside the ring. Aromatic residues could produce an edge-to-face interaction, as opposed to the face-to-face - stacking of the rings. In DNA, approximately half of the bases are hetero-double cyclic. The enthalpic contribution of a single edge-to-face weakly polar interaction is independent of the number of rings in each member of the pair, but the energy of - (parallel ring) stacking increases markedly as the surface areas of the ring systems increase. For heterocycles, parallel stacking is competitive with -and may be more favorable than- perpendicular interaction.

van der Waals Interactions

•These interactions result from asymmetry of electrons within the atom. At an optimal distance between atoms (the van der Waals contact distance). •The asymmetry between electrons can be complementary between two atoms.•Typical van der Waals interactions have energies of 0.5 to 1.0 kcal/mole.

Propiedades físicas del DNA que derivan de las interacciones

arriba mencionadasRe-visita rápida

Denaturation changes physical properties of DNA

• Chemical Stability of nucleic acids– DNA is stable to mild H+ , OH- – RNA is rapidly degraded by [OH-]

• Isolated Chromosomal DNA is viscous but mechanical forces readily break DNA (viscosity decreases)

• Pipeting• Sonication• Shearing

• dsDNA is denatured by– alkaline pH– heat– solvent

Fig. 23-15

Heat denaturation of DNA

• hyperchromic shift :– 40% increased

absorbance over a narrow temperature range

– cooperativity

• melting curve– midpt is its melting

temperature Tmss polyAfig. 23-21

Overall GC content is reflected in buoyant density

• CsCl forms a density gradient in a centrifugal field• The buoyant density of DNA differs between species

– Satellite DNAs (repetitive DNAs) may have distinct GC content

Tm is a function of GC content and ionic strength

• Tm= 81.5-16.6(log10[Na+]) + 0.41(%G+C)-

600/N– N= chain length– Accurate ~ 10-3 M< [Na+] < 1 M

• Decreases in ionic strength decrease Tm

• Primer (olignonucleotide) annealing: Tm 2o C X (A+T) + 4o (G+C)

Denatured DNA can be renatured

• Melt and quick cooled ~25o below Tm

• Short complementary regions anneal• Annealing is a cooperative process• By manipulating temperature and salt

concentration, reannealing is precise and sequence dependent

• Sequence specific reannealing underlies many experimental methods in molecular biology– Southern and northern blotting

– Amplification of individual genes by PCR reactions

Reference

• N.M. Luscombe et al, Nucl. Acid Res 29, 2860-2874 (2001).

• Luger et al, Nature 389, 251-260 (1997)

La tecnología de la hibridación

Southern and Northern blotting and hybridization detect complementary

sequences

• Detect mutant alleles (RFLPs) [Southern]

• Homologous genes between organisms

• mRNAs corresponding to a particular gene (Northern)

What is hybridization?

• Complementary base pairing of two single strands of nucleic acid double strand product– DNA/DNA– RNA/RNA– DNA/RNA

What holds the two strands together?

• Hydrogen bonds between the base pairs

What holds the two strands together?

• Hydrophobic interactions of stacked bases

• van der Waals forces between stacked bases

Factors affecting the strength of strand pairing

• Number of GC pairs vs. AT pairs

• Mismatch

• Length of hybridizing strands

• [Salt] of hybridization solution

• Temperature

• Concentrations of denaturants

Factors affecting the strength of strand pairing

• Number of GC pairs vs. number of AT pairs– The more H-bonds between

strands, the more strongly they are held together

• 3 H-bonds between G and C• 2 H-bonds between A and T

– So…the more GC pairs, the more H-bonds between strands

Factors affecting the strength of strand pairing

• % Mismatch – the greater the lack of complementarity,

• the fewer hydrogen bonds

– the lower the strength of the hybrid

Factors affecting the strength of strand pairing

• Length of hybridizing strands– the longer the strands,

• the more hydrogen bonds and• the more hydrophobic interactions, so

– the greater the strength of the hybrid

Factors affecting the strength of strand pairing

• [salt] of solution [salt] strength of the hybrid

– negative charges of the phosphate moieties of the sugar-phosphate backbones repel each other

– + ions from salts in solution act as counterions to reduce repulsion

• Monovalent cations (Na+)• Divalent cations (1 mM Mg++ = 100 mM Na+)

» Why does [Mg++] affect specificity of PCR priming?

Factors affecting the strength of strand pairing

• Temperature– heat increases the kinetic energy of each of the

two strands– sufficient heat makes kinetic energy > H-bond

energy – strands separate

Factors affecting the strength of strand pairing

• pH– [OH- ], ~pH 12

• enolic hydroxyl groups on bases ionize• keto-amino H-bonds disrupted

• Concentration of denaturants– formamide, urea

Combined effects of these factors can be expressed as equations

for the Tm• What is Tm?

• Equation to estimate Tm for DNA oligonucleotides

• Equation to estimate Tm for polynucleotides

What is Tm?

• Tm = temperature of melting or separation of strands– Tm is a function of the DNA fragment or RNA strand

under consideration and the solution in which the hybridization is occuring.

• Changing the temperature does not change the Tm!

What is Tm?• For complementary oligonucleotides (10 - 23 nt)

– Temp at which 50% of complementary molecules exist as single strands

50%

5’ - - - - - - - - - - - - - 3’

3’ - - - - - - - - - - - - - 5’

50%5’ - - - - - - - - - - - - - 3’

3’ -

- - -

- - -

- - -

- - -

5’

What is Tm?

• For complementary polynucleotides (>~25nt)– Tm is the temp at which 50% of hydrogen

bonds within any one hybrid are broken

Combined effects of factors contributing to strength of a hybrid can be expressed

as equations for Tm

• for DNA oligonucleotides in 1.0M Na+

Tm (oC) = 4 (G+C) + 2 (A+T)

• Note: how does this equation account for– length?– % GC?– The conditions of the solution

Combined effects can be expressed as equations for Tm

• for DNA polynucleotides and oligos as short as 14 nt

Tm = 81.4 + 16.6 log [(M+)/1+0.7(M+)]

+ 0.41 (%G+C) - 600/L - %mismatch

- 0.65 (% formamide)

M+ = monovalent cation concentration

L = length of probe sequence

Tm for polynucleotides (cont’d)

• How does the equation on the previous slide account for– length?– % GC?– The conditions of the solution

Membrane hybridization

• One nucleic acid component is affixed to membrane; the other is in solution– probe(s) affixed; sample in solution

• HLA-DQalpha

– samples affixed; probe(s) in solution• 14;18 translocation

• Membrane material binds DNA or RNA– nylon– charged nylon– nitrocellulose

Steps in membrane hybridization

• blocking or prehybridization

• hybridization

• wash or rinse

• visualization

Blocking/prehybridization

• Why?– Remember, membrane binds nucleic acid, so

• labeled nucleic acid in hybridization solution can bind everywhere on membrane background

Blocking/prehybridization

• How?

– Membrane with affixed nucleic acid is bathed in blocking solution at hybridization temperature

– Components of blocking solution bind non-specifically to membrane to prevent labeled nucleic acid from binding except to complementary strands

Blocking/prehybridization• common blocking agents

– sodium dodecyl sulfate (SDS)– nonfat dry milk– bovine serum albumin– Ficoll

(carbohydrate polymer)

– polyvinylpyrollidone (PVP)

Hybridization• What?

– Labeled nucleic acid in solution is allowed to anneal to affixed complementary strands

• Conditions– Must be determined empirically – Hybridization solution includes

• [Salt] determined from Tm formulas• Membrane blocking agents • Denatured labeled nucleic acid; denatured by

– High temperature (95oC) or– Alkaline (high pH) conditions

Hybridization• Conditions (cont’d)

– Temp set below Tm to optimize rate of hybridization

• oligonucleotides: 15o below Tm• polynucleotides: 15-35o below Tm

Wash/rinse

• Why?– To remove labeled probe/sample that is

• in excess • non-specifically bound • bound with loose complementarity

Wash/rinse How?

• Bathe membrane in solution lacking labeled probe/sample• Use stringency conditions that minimize non-specific

hybridization– stringency = likelihood that two strands will separate

• Be aware that wash conditions for oligonucleotide and polynucleotide hybridizations differ because:– oligonucleotide hybrids are not in equilibrium– polynucleotide hybrids are in equilibrium

Choosing wash conditions

– To wash polynucleotide hybridizations (equilibrium) • raise stringency conditions to make it harder for

imperfect hybrids to remain annealed• perform washes just below the Tm

– stringency likelihood that two strands will separate

• Lower the salt concentration• Raise the temperature• Include denaturants

Choosing wash conditions (cont’d)

• To wash oligonucleotide hybridizations– Use stringency similar to or lower than

hybridization condtions• Same or lower temperature• Same or higher salt concentrations

– Short time periods

Visualization

• requires a visible signal– radioactive– non-radioactive, enzyme linked– non-radioactive, non-enzymatic

• e.g., use of fluorescent label

• for enzyme-linked signal generation– additional block and rinse steps required

• avoid conditions which will disrupt hybrids

Websites to use molecular models

Molecules in Motion http://www.umass.edu/molvis/freichsman/index.html

Molecules from Chemistry http://www.ouc.bc.ca/chem/molecule/molecule.html

Protein Data Back

http://www.ncbi.nlm.nih.gov/Structure/

Klotho Biochemical Structure Database

http://www.ibc.wustl.edu/moirai/klotho/