7/23/2019 Planos de Falsa Escuadra

1/6

Project: Sliding bevel square Page 1 of 6

Sliding bevel square

A sliding bevel square, which is an essential tool for marking out dovetails and other joints with angles, can be made on

the same lines as the try square . Again the dimension given are only for guidance.

http://www.craftsmanspace.com/

7/23/2019 Planos de Falsa Escuadra

2/6

Proje

Parts list

http://www.craftsmanspace.com/

7/23/2019 Planos de Falsa Escuadra

3/6

Proje

Assembly drawing

http://www.craftsmanspace.com/

7/23/2019 Planos de Falsa Escuadra

4/6

Proje

1. Stock

http://www.craftsmanspace.com/

7/23/2019 Planos de Falsa Escuadra

5/6

Proje

2. Straight Edge

http://www.craftsmanspace.com/

7/23/2019 Planos de Falsa Escuadra

6/6

Project: Sliding bevel square Page 6 of 6

Standard parts

Assemblage instructions

1. Mark a central point 20mm from the end of the stock and drill a D6mm hole. Fit the straight edge into the socket.

2. Pass the screw through this hole and the two washers and tighten the wing nut.

http://www.craftsmanspace.com/