1 llave hexagona 2,5 mm kit instalado · 1- afloje el tornillo ubicado en el punto a de la imagen...
TRANSCRIPT
Calle 76 # 52D - 74 / Telefax: (57+4) 448 8428 / Medellín - Colombia www.mastechno.com
KAWASAKI Z 250 SL
Montaje para Sliders
1- Afloje el tornillo ubicado en el punto A de la Imagen 1
2- Retire el tornillo original de la Moto y remplacelo por el TC 3, Utilize la tuerca original.
3- Instale en cada lado simultáneamente el slider como lo indica el Esquema 1
Kit Instalado
Al terminar la instalación de las partes, verifique que estén alineadas y que toda la tornillería esté debidamente apretada; reajuste todos los tornillos.
Nota:No apriete todos los tornillos hasta que no estén completamente alineadas todas las perforaciones con respecto a los puntos de sujeción.
y las piezas esten completas.Herramientas: 2 Rachet + 2 Extensiones
2 Copas 14 mm 1 Copa 15 mm1 llave Hexagona 2,5 mm
Instalación
Imagen 1
A
Esquema 1
Tornillo HexagonalM10 X 390 P1.25
Buje aluminioslider
Platina botónMASTECHBuje nylon Slider Arandela InternaTornillo button
M4 X 16 Inox
2Cantidad2CantidadPL1TC2 TC3TC1BJ2BJ1
2Cantidad4Cantidad 2Cantidad Cantidad 1
Calle 76 # 52D - 74 / Telefax: (57+4) 448 8428 / Medellín - Colombia www.mastechno.com
KAWASAKI Z 250 SL
1- Loosen the bolt located in point A of Image 1
2- Remove the original bolt of the motorcycle and replace by TC 3 bolt, Use the original Nut
3- Install in both side the slider as indicate in the Diagram 1
Assembled Kit
Tools Required: Two Ratchet + Two 150 mm Extension BarsTwo 14 mm Sucket One 5 mm SucketHex key 2,5 mm
Instalation
Parts Included: Image 1
A
Diagram 1
Hexagonal BoltM10 X 390 P1.25
Aluminium SliderBushing
MASTECHButton Nylon Bushing Internal WasherAllen Bolt
M4 X 16 SST
2Quanty QuantyQuanty Quanty Quanty2QuantyPL1TC2 TC3TC1BJ2BJ1
24 2 1
Assembly Instructions for Slider
Note :Do not tighten the screws until they are completely aligned with the holes. Before the installation, please verify through the manual that all pieces and parts are complete.
After the installation of the parts, please check that they are aligned and that all the hardware is properly tightened